Top 9 Leaf Blower Dryer Vent

The MV-90 is designed for when the vent path takes a 90 degree turn, such as down through the floor, up through the ceiling, or off to the side. -The MV-90 can handle offsets up to 3 inches from center to center. The more accurately you line up the MV-90 with the vent on the back of your dryer, the better the vent path and the further back you can locate your dryer. Normally, the MV-90 requires 5 1/2 inches of clearance behind the dryer. If an obstruction necessitates you locate the MV-90 at the maximum 3 inch offset, then your dryer will need to sit out an additional 3 inches to allow for a bend radius in the transition duct. -Close vent offsets between dryer and wall vent located on same wall as dryer (Offsets between 6-9 inches): The MV-90 can be coupled directly to a standard 4 inch diameter, adjustable, 90 degree elbow which creates a 9 inch offset. See photo below. If your same wall offset is 6 inches, you can use the MV-90 and an elbow, taking advantage of its ability to handle misalignment up to 3 inches. -Same wall offsets greater than 9 inches: Simply mount the MV-90 directly behind your dryer, plug the 90 degree elbow into the wall vent, and measure for the required length of rigid metal pipe between them. Make sure to measure from where the pipe will stop on the MV-90 to the stop on the male end of the rigid metal pipe. -Close vent offsets between dryer and wall vent located on same wall as dryer (Offsets between 0-3 inches): If your same wall offset is between 0 and 3 inches, then the MV-180 is the product for you.

Product Description

This is a genuine replacement part. The model number and name for the following item is: Thermal Fuse 6931EL3003D LG fuse thermal fuse breaker.

From the Manufacturer

This is a genuine replacement part. The model number and name for the following item is: Thermal Fuse 6931EL3003D LG fuse thermal fuse breaker

The Arctic Cove 8 oz. nozzle cleaner is specialty cleaner that safely cleans misting nozzles. It is safe to use on brass, stainless steel and plastic. This cleaner extends misting nozzle life and it easy to use.

This Attwood Turbo 4000 Series II In-Line Blower provides outstanding ventilation airflow for areas such as engine compartments, galleys, bilges, and heads. It features a patented, in-line design and the 5-blade fan maximizes airflow and efficiency. The blade sweep and pitch are engineered for a high lift coefficient, which results in increased airflow speed for optimized ventilation. It matches the airflow of competitive in-line blowers with significantly reduced noise output. For added durability, it has an engineered plastic housing that resists deformation during installation, and prevents blade-to-housing interference. No other bilge blowers in the industry provide such powerful system output at such low power input in a compact size. System airflow exceeds older-style in-line blowers by as much as 25 percent. It is also up to four times more efficient than competitive blowers as it draws up to 40 percent fewer amps. This blower is marine ignition protected and has built-in mounting feet that permit easy vertical or horizontal installation. This 12-volt, water-resistant white blower is intended for use with 4-inch interior diameter ventilation hose. It installs with #10 fasteners. Attwood Corporation has been an award-winning leader in engineering, testing, and manufacturing of the highest quality marine products for over 100 years. We deliver safe and reliable lighting, fuel systems, water systems, seating & pedestals, swim ladders, custom upholstery, and general marine accessories that are easy to install and meet regulatory compliance.