Top 10 How To Turn Your Fridge Into A Kegerator

Specification:
Temperature Control Range: -50~99°C / -58~210°F
Temperature Resolution: 0.1°C / 0.1°F Temperature Accuracy: ±1°C (-50~70°C) / ±1°F (-50~160°F)
Temperature Control Mode :On/Off Control, Heating and Cooling
Input Power: 100 ~240VAC, 50Hz/60Hz
Temperature Control Output: Max. 10A, 100V~240V AC
Buzzer Alarm: High and Low Temperature Alarm
Sensor Type: NTC sensor (Including)
Sensor Length: 2m / 6.56ft
Input Power Cable Length: 1.5m (5ft)
Output Power Cable Length: 30cm (1ft)
Body Dimension: 140x68x33mm (5.5×2.7×1.3inch)
Socket Dimension: 85x42x24mm (3.3×1.7x1inch)
Ambient Temperature: -30~75°C / -22~167°F
Storage Temperature: -20~60°C / -4~140°F
Humidity: 20~85% (No Condensate)
Warranty: 1 Year

Package Included:
1x ITC-308 Temperature Controller
1x Manual

This mini dehumidifier has been design to adsorb moisture from small enclosed areas (maximum area: 10’x 10′). It will help protect clothes and valuables from the damaging effects of mold/mildew and moisture rot. It is 100% renewable and needs no power to operate. Just hang the eva-dry unit in a closet, or you can place it in other small enclosed spaces, and it will start to adsorb moisture. There are no batteries required or cords to plug in, the unit works without power. There is an indicator window with special “moisture meter crystals” that change from orange (when dry) to green (when wet) to indicate when the unit needs to be “renewed”. The unit will adsorb approximately 8 to 10 ounces of moisture (depending on humidity levels this should take between 3 – 8 weeks). Once the moisture has been adsorbed it cannot leak or spill. This unit uses a specialized engineered crystallized silica gel that is odorless, non-toxic and completely safe. When the indicator crystals turn Green it is time to “re-new” the unit. Simply remove the unit from where it is adsorbing moisture and plug it into a power outlet.

The Standard Double Keg Kegerator Conversion Kit comes with everything you will need to successfully convert your refrigerator or chest freezer into a two product draft beer cooler. This keg tap kit is designed to run two completely separate kegs. Depending upon your refrigerator capacity, you can run 2 full size kegs, 2 pony kegs, 2 6 gallon kegs or any combination you choose. All the draft beer parts are of the highest commercial grade quality which are designed and built to last. Please Note: Beverage Factory is the only Authorized Reseller of Kegco products. Products purchased outside of Beverage Factory are not genuine Kegco parts and will not be covered under Kegco’s 1-year warranty.

Product Description

Specification: • Overall Dimension: 4.8 x 2.5 x 4.8 inches • Item Weight: 1 pound • Size: 10 • Color: White • Power Source: Corded-electric • Temperature: 50°F to 120°F • Voltage: 120 volt • Warranty: 10 Years This Ventamatic Replacement Thermostat controls power attic ventilators to promote the equalization of temperatures inside and outside your attic. Temperature Range F 183, Accessory Type Ventilation accessory. Firestat safety feature shuts fan off at 183F Controls up to three units, not to exceed 10 amps. It provides energy-efficient operation of power attic ventilators Temperature range from 50 degrees to 120 degrees Fahrenheit Temperature is fan On/Off 10-Amp adjustable thermostat Adjustable bi-metallic switch Product Description This Ventamatic Replacement Thermostat controls power attic ventilators to promote the equalization of temperatures inside and outside your attic. Temperature Range F 183, Accessory Type Ventilation accessory. Firestat safety feature shuts fan off at 183F Controls up to three units, not to exceed 10 amps. From the Manufacturer 10-Amp automatic adjustable thermostat with Firestat. For the energy efficient control of roof or gable power attic ventilators. Temperature range from 50 to 120 Degree Fahrenheit.

From the Manufacturer

10-Amp automatic adjustable thermostat with Firestat. For the energy efficient control of roof or gable power attic ventilators. Temperature range from 50 to 120 Degree Fahrenheit.

Specifications
• Attractive, durable chrome finished, food grade stainless steel 64 oz keg Coffee spear with pressure relieving valve
• Stout Creamer Faucet – Essential for getting the trademark lacy foam of a good Guinness or a frothy iced coffee, without the need of dairy or creamer! Dual-action pour lets you add a creamy top to your pour.
• Cartridge holder casing – System is compatible with 8g nitrogen cartridge or nitrogen oxide capsules (Nitrogen capsule NOT included!)
• Faucet/Tower Combo Wrench – Makes installing or removing faucets and tower shanks easy! This 2-in-1 tool can remove hard-to-reach tower shank nuts, and includes a pin wrench for tightening/removing faucet collars.
• 2 Headed Cleaning Brush – Clean every part of your kit, including the tubing, faucets, and other hard-to-reach places! Features a different size brush on each end of a flexible handle.
• 1 x 32-inch plastic hose
• Dimensions: 7″ x 13.9″ x 7″
• Weight: 5.45 lbs

Instructions
• Kit is not compatible with dishwasher, microwave, freezer, hot liquids, or highly acidic materials
• Before each use fill the keg with hot water and add 1 tablespoon baking soda or powdered wash; Shake until water runs from the top and allow to soak for 10 minutes; Use nylon keg brush to clean nitro keg; Rinse other pieces with hot water and allow to air dry completely before use or storage

Quick Start Guide
• 1. Add coffee concentrate and water to the keg.
• 2. Install the faucet.
• 3. Put the nitrogen capsules in nitrogen jacket.
• 4. Screwing the nitrogen jacket until you hear a hissing noise.
• 5. Shake the keg well, then, put it in refrigerator for more than 1 hour.
• 6. Enjoy your nitro cold brew coffee!
• Note: Please do not worry if you find the faucet is dripping when you close it.

Eva-Dry Electric Petite Dehumidifier With Peltier (No Compressor) Technology Which Makes It Light And Quiet. The Unit Draws Humid Air In And Heats It Over A Warm Plate Inside The Dehumidifier, Then Cools The Air Causing Condensation Which Is Trapped In The Removable, Spill-Proof Reservoir. Dry Air Is Then Expelled Out. Features An Automatic Water Level Detector Switch To Indicate That The Tank Is Full. Ideal For Bathrooms, Boats, Campers, Counter Tops, And More. Works Well In Areas Up To 1100 Cubic Feet. Absorbs 8 Ounces Of Moisture In A 24 Hour Period With Relative Humidity Of 80% At 86 Degrees Fahrenheit. 4-1/2″ W X 8-1/2″ H X 6″ L. White. 1 Year Limited Warranty.

Use this handy controller to regulate the temperature in your freezer between 20 – 80F . Great for turning a chest freezer into a keg refrigerator. Strictly a mechanical thermostat for cooling only, it is simple to use and economical. It operates with a gas filled probe on a 6-foot capillary tube. When the gas contracts or expands in the probe, it triggers a mechanical device inside the control which turns the power on or off. There is no probe temperature readout on the dial, so keeping a thermometer inside the refrigerator is highly recommended to keep track of the actual temperature. On most refrigerators, the controller will allow a usable range of 37 to 80 F, while on freezers, the controller will be able to reach its full 20 to 80 F range. Features: Made of stainless steel. Adjustable with the turn of a knob. No drilling necessary. Plug unit into wall and then run the sensor into your freezer. Male and female plug in one. Specs: Temperature dimensions: 4 3/8″ H x 2 1/8″ W x 1 1/2″ D. Cord dimensions: 6′. Remote sensor bulb: 5 1/2″W. Remote sensor bulb capillary tube: 6′. Temperature range: 20 – 80F. Voltage: 120 VAC.

The WH1436 temperature controller can turn on/off an electric appliances at desired temperature.
For example, you can use the controller to turn on a heater at 99.9 F and turn it off at 100 F. Or turn on a freeze at 52 F and turn it off at 45.3 F.
(Please be noted that the controller itself doesn’t change temp. You need to use heater or refrigeration equipment with it.)

Main features:
1-YEAR WARRANTY: From the date of purchase.
Plug and play. No worry about wiring.
Maximum load: 880W @110V or 1960W @240V.
Heating OR refrigeration working mode.
Celsius or fahrenheit read-out.
Temperature calibration.
Compressor delay protection time setting.
High and low temperature alarms are available(This is a useful function. You can use this feature to alarm you when the temperature overshoots your desired temperature)
Auto shut off timer(It doesn’t turn off the controller itself. The timer just turns off the load when specified minutes counts down to 0.)

Specification:
1.Power supply: AC 110V 50/60Hz
2.Measure range: -58 ~ 230 F(-50 ~ 110 C)
3.Temperature resolution: 0.1
4.Accuracy: ±0.5
5.Working mode: Heating OR Cooling mode
6.Slew range of temp controlling: 0.1 – 230(difference between turn-on degree and turn-off degree)
7.Control resolution: 0.1
8.Power consumption: less than 3W
9.Relay contact capacity: 10A
10.Store setting after power off: YES
11.Compressor delay protection: YES
12.High and Low Temperature alarm: Yes
13.Product size: 4.9×3.6×1.8 inch (12.5×9.1×4.5 cm)
14.Sensor Cable length: 3m(9.8ft)
Advanced function:
1.Switch temperature unit(Default: F): F or C
2.Switch resolution(Default:0.1): 0.1 or 1
3.Auto shut off timer(Default:OFF)

Package Content:
1x WH1436A Temperature controller
1x sensor cable

Product Description

We love beer. But many of our favorite microbrews aren’t sold in bottles. The uKeg is the world’s most innovative draft beer growler. It keeps beer fresh, cold and carbonated, and goes wherever you go. Toast to flavor and friends. With a uKeg, your favorite beer will stay brewery fresh to the last pint, whether poured from your refrigerator or from your tailgate.

From the Manufacturer

Soak It In

Close your eyes and savor the aroma and flavor of fresh, delicious draft beer the way the brewer intended. Fill the uKeg with confidence, knowing your beer will stay carbonated for weeks and cold all day. The perfect pour you’re looking for.

Share With Friends

Here’s to a great beer, shared among friends. The uKeg is the ultimate in portability, ready to join you and your crew wherever you roam. Toast your favorite beer, homebrew or perfect cocktail to life’s adventures and the people by your side.

---

Vacuum Insulation

Durable 18/8 stainless steel keeps beer cold all day.

VPR Technology

Adjustable cap with pressure gauge maintains carbonation from 0 to 15 psi as desired.

Custom Tap

Locking dispenser with interchangeable handle makes you the barkeep and the boss.

---

Find Your Perfect Place

Seek the good life with the perfect beverage in your hand. By your side, the uKeg pours fresh to the last drop goodness wherever you escape to.

---

About the Startup

Describe your product in 3 words.

Craft. Innovation. Ease

How did you come up with the idea for this product?

A love of good beer, and a desire the make the experience better. We’re beer lovers living in a beer region. Who knows which came first, the love or the beer, but as engineers we recognized the need for a better solution. We decided to focus our skills and efforts on this endeavor.

What makes your product special?

After testing all the available options, we realized nobody had cracked the code on a pressurized growler that works. So we designed the uKeg: It’s easy to use, with an automatic regulator cap and integrated CO2, variable carbonation from zero (off) up to 15 psi, and a dispensing tap so you can easily pour beer without removing the cap. It also has a liquid sight glass, an ergonomic handle, and it’s easy to clean.

What has been the best part of your startup experience?

Ideas are fun and creative, and turning those ideas into high quality products is challenging. We’ve focused our deep engineering and design experience to produce a high quality product. It takes a lot of work and coordination to get it right, and we’re proud when our beer-loving customers are happy.