The Best Does Ao Smith Stand Behind Their Water Heater Warranty

SAVE ENERGY, WATER, MONEY, TIME – Atmor offers the efficient and convenient water heating solution you have been looking for. Atmor 3kW/ 110V Point-of-Use Tankless Electric Instant Water Heater provides an unlimited flow of hot water without the wait or worry of ever running out. That’s right, instant hot water on demand! This unit is specifically designed for hand washing SINGLE SINKS in areas with at least 57°F ground water temps (See Sizing Guide). Please note that this unit will not operate properly in Northern regions with inlet water temps colder than 57 degrees. A flow rate of 0.5 gallon per minute (GPM) is required in order to achieve a 45° temperature rise. Perfect for residential and commercial use, this compact unit can be installed against the wall either under the sink out of sight or near the point of use. Unit requires a 30 Amp dedicated single-phase breaker. This is NOT a plug in unit. Required wire size: 10 AWG. Standard 1/2″ NPT (straight thread) fittings. Maximum flow rate is 0.5 GPM. Maximum temperature rise possible for unit is 45°F. For safety reasons, the included Pressure Relief Device (PRD) included must be installed on your water heater per the instructions in the owner’s manual. In order to achieve maximum performance, it is recommended to install the included 0.5 GPM sink aerator. Failure to comply with the installation and operating instructions in our Owners Manual or improper use will void the warranty. The water heater must be installed by a licensed electrician in compliance with all local and building regulations.

Get hot water where it’s needed, when it’s needed with the Bosch ES4 Tronic 3000 T Electric water heater. This 2.5-gallon capacity point-of-use mini-tank fits right under your sink and provides a practical and effective solution to your hot water needs. This smaller model can be plugged right into a 120-volt outlet with the 36-37″ cord, or can be installed in-line with a larger hot water source to provide “on-demand” use. The glass-lined tank offers great insulation and added durability, while the heater’s fast recovery rate eliminates long waits for hot water. An external dial allows you to easily control the temperature range, and the temperature-and-pressure relief valve enhances your safety. The ES4 Tronic 3000 T from Bosch has a sleek and attractive exterior design that blends in seamlessly with existing décor when installed in a visible location, making this heater a great option in any room.

120V – requires hard wiring. 1440W element. Magnesium anode rod. Rectangular shape with 2″ of foam insulation. Glass lined tank for longer life. 6 year warranty on heater and 1 year warranty on parts for both commercial and residential use. Temperature/pressure relief valve included. Can be mounted both horizontally or vertically. Mounts on floor or wall. Meets ASHRAE 90.1. See Info Page for technical and installation specifications.

Please feel free to contact us directly to determine if this is the correct gas valve for your water heater!!! We will need the model and serial number of the water heater to cross reference properly. The electronic gas control valve incorporates an LED status indicator that monitors system operation and service diagnostics. Gas control located within hot water heater uses a thermopile to generate the power needed to operate the electronic gas control without requiring an external power source. This product has been certified by a third party to be compliant with the “Safe Drinking Water Act” requirements for low lead in potable (human consumption – drinking and cooking) and non-potable water applications (non-human consumption). Thermostat is compatible with all A.O. Smith branded heaters including A.O. Smith, State Water Heaters, American Water Heater, Whirlpool, Craftmaster and Reliance. Product manufactured by Honeywell for A.O. Smith. Honeywell model # WV8840B1158

Please feel free to contact us directly to determine if this is the correct gas valve for your water heater!!! We will need the model and serial number of the water heater to cross reference properly. Installing the valve and then returning used is prohibited. The electronic gas control valve incorporates an LED status indicator that monitors system operation and service diagnostics. Gas control located within hot water heater uses a thermopile to generate the power needed to operate the electronic gas control without requiring an external power source. This product has been certified by a third party to be compliant with the “Safe Drinking Water Act” requirements for low lead in potable (human consumption – drinking and cooking) and non-potable water applications (non-human consumption). Thermostat is compatible with all A.O. Smith branded heaters including A.O. Smith, State Water Heaters, American Water Heater, and Reliance.

Product Description

Intermatic Water Heater Timer, Series: Intermatic, Steel, Gray, 7-3/4 in Height x 5 in Width x 3 in Thick, Standards: CSA Certified, 10000 W, 40 A, 240 V, 60 Hz Capacity, DPST Switch, For Residential, Commercial, Industrial, Institutional/Schools and Military Facilities. “The WH40 Mechanical Water Heater Time Switch regulates electric water heaters. Daily operation can be set with trippers from 1 to 23 hours. Enables shifting electricity use into off-peak time periods to reduce utility cost. Designed for industrial, commercial and residential applications DPST 208-277 Volts Electrical rating: 40 amps per pole, 60 Hz Minimum on/off time – 1 hour Includes 3 sets of on/off trippers Convenient external override switch Gray finish Steel NEMA 1 indoor enclosure Combination 1/2″” – 3/4″” knockouts 7-3/4″”H x 5″”W x 3″”D”.

From the Manufacturer

This Intermatic “Little Gray Box” electric water heater timer will provide up to 26% savings for your electric water heater. To maximize the savings, the timer should be used to operate one hour in the morning and two hours in the evening, set to turn “ON” one hour in advance of the usage periods. The trippers may be set from 1 to 23 hours. Three sets of trippers are included. It also provides a convenient external override switch. It is easy to use.

Product Description

Eastman 86278 Galvanized Steel Water Heater Stand features x-bracing for additional strength and safety clips for securing to the wall or floor. The high-quality galvanized steel construction has a safe loading rate of up to 650 pounds or up to 60-gallon water heaters. Ideally used to meet safety requirements by raising water heater to an acceptable area for code compliance. This reduces the risk of fire and property damage caused by unstable water heaters. The included hardware makes the installation straightforward and simple, even for non-plumbers.

From the Manufacturer

Eastman’s new Water Heater Stand features x-bracing for additional strength, and safety clips for securing to the wall or floor. The water heater stand is rated for up to 900 pounds. For use with up to 65 gallon water heaters.

Product Description

Kickspace heaters have a low-profile design that provides floor-level heat from an out-of-the-way location. Great idea for light-commercial applications such as ticket/toll booths or checkout counters where ducting isn’t possible. Factory wired at 1500W at 240VAC can be easily converted to 750W or 1500W at 120V for added versatility. White grille has a baked enamel finish and one-piece design for durability. Vertical louvers disperse heat evenly across the width of the grille. Control temperature with optional line voltage thermostat (Model 86W) or timer (Models 59V or 59W 60-minute timer or Models 61V or 61W 15-minute timer) for a simple and convenient way to control the heater. Integral thermostat kit (Model 90) also available. No extended warm up time due to an efficient steel sheathed, plate-finned heating element that provides comfortable heat in seconds. Quiet, thermally protected motor shuts off in event of overheating and transverse blower circulates heated air for optimal room warming. UL Listed for safety. Slim design tucks under cabinet kickspaces, vanities, stairways or any place where space is limited and a little extra heat is desired to make your environment cozier. Kickspace heaters are intended to provide supplemental heat from a wall location and not to take the place of a home’s main heat source.

From the Manufacturer

Since 1932, Broan-NuTone LLC has led the industry with forward-thinking residential ventilation products, unsurpassed built-in convenience products and superior customer service. While global expertise plays a critical role in Broan-NuTone’s ability to being able to meet and exceed the needs and desires of homeowners and designers alike, Broan-NuTone is very proud of the fact that over 80 percent of their products sold in the United States are designed, engineered and manufactured in the United States with U.S. and imported parts. Manufacturing operations in the United States are located in Hartford, Wisconsin and Cleburne, Texas, with customer and technical services located in Hartford and in Cincinnati, Ohio. Broan-NuTone is committed to developing revolutionary products that improve the indoor environment as well as implementing procedures to preserve the outdoor environment. Broan is the industry leader of range hoods, ventilation fans, heater/fan/light combination units, Indoor Air Quality (IAQ) Fresh Air Systems, built-in heaters, whole-house fans, solar powered attic ventilators and trash compactors. NuTone holds major market positions in door chimes, central vacuum systems, stereo intercom systems, home theater speakers, medicine cabinets, ironing centers, ceiling fans and ventilation fans. BEST range hoods are the “Ultimate in Kitchen Ventilation” featuring state-of-the-art performance and Italian design.

The LG 7,500 BTU 115V window-mounted air conditioner with 3,850 BTU supplemental heat function gives you everything you love about an air conditioner and more! whether it’s cold in April or hot in October, this unit has you covered so you can always feel comfortable at home. In addition to cooling, this versatile unit offers supplemental heating, providing you with an additional heat source to your main heat source when outdoor temperatures are above 45 degrees Fahrenheit.

Water Heater Nitride Ignitor and Flame Sensor Assembly for AO Smith part number 9003626005. 5 Connection Molex Plug. Metal mounting Bracket.